国产日韩无 I 亚洲观看视频 I 欧美性性性性性色大片免费的 I 成人动漫在线观看 I 一级做a爱片性色毛片www I 夜色约爱网站 I 欧美美女色 I 国产aa视频 I 久久久久国产精品无码免费看 I 国产免费av网 I 2018中文字幕第一页 I 999在线观看精品免费不卡网站 I 国产精品久久久精品 I 国产国产人免费人成免费视频 I 孕妇特级毛片ww无码内射 I 婷婷激情四射 I 免费观看欧美猛交视频黑人 I 国产免费色视频 I 日本a级黄绝片a一级啪啪 I www.爱色av.com I 免费在线观看小视频 I 欧美日本免费 I 亚洲 高清 在线 I 国产九色 I 久久国产亚洲精品超碰热 I 欧美wwwwww I 狠狠操影院 I 免费污视频在线 I 四虎海外永久 I 色偷偷亚洲精品一区二区 I 亚洲国产精品精华液999 I 精品美女永久免费视频 I 成人动漫黄在线观看 I 美女在线免费网站 I 麻豆久久精品

1. The evaporator often fails to defrost
Evaporator electrical heating tube is very easy to burn out, and as the evaporator with heating tube series electric heating tube is made up of 2 a group, one of the burning, lines can not work normally, so the frost on the evaporator ontology can't melt.
2. The collecting pan freezes
Water dish inside is not set electric heating tube, although has the same electric heating wire and the water pipe, but power is very small, poor quality, often fails, due to the low temperature temperature reached - 18 ℃ below, after the evaporator defrosting, water entering the water pan is too late to discharge will regelation, cannot normal run off through the drain pipe.
3. The downpipe is blocked with ice
The electrical heating wire of the downpipe is out of order. Because the electric heating wire of the downpipe is always in working state, and its own quality is poor, the failure rate of the electric heating wire of the downpipe is very high. As the original downpipe was long, once its electric heating wire failed, in the low temperature environment, the water entering the downpipe began to freeze again before it could flow away, and the defrosting could not be realized normally all the time.
Improvement measures:
1. The main reason why the evaporator cannot melt frost is that the quality of electric heating is saved in the problem, and the series method is used. Therefore, we should use the heating tube with rated voltage of 220v and use parallel connection.
2. Re-customize the water collecting plate to ensure that the water from the evaporator defrosting will not freeze twice after it reaches the water collecting plate.
3. The improved cut-off of the downpipe is to shorten the downpipe as much as possible, add another collecting bucket under the collecting pan, and replace the new collecting bucket before the water in the collecting bucket is full.